NASA research pilot Gordon Fullerton ''flying'' in the MD-11 simulator during the Propulsion Controlled Aircraft (PCA) project. This investigation grew out of the crash of a DC-10 airliner on July 19, 1989, following an explosion in the rear engine which caused the loss of all manual flight controls. The flight crew attempted to control the airliner using only the thrust from the two remaining engines. Although the DC-10 crashed during the landing attempt, 184 of the 296 passengers and crew aboard survived. The PCA effort at the Dryden Flight Research Center grew out of the crash, and attempted to develop a means to successfully land an aircraft using only engine thrust. After more than five years of work, on August 29, 1995, Gordon Fullerton made the first PCA touchdown aboard an MD-11 airliner (a later version of the DC-10). The concept was further refined over the years that followed this first landing. Simulators were essential ingredients of the PCA development process. The feasibility of the concept was first tested with an F-15 simulator, then the results of actual flight tests in an F-15 were incorporated back into the simulator. Additional simulations were run on the Boeing 720 airliner simulator used in the Controlled Impact Demonstration project. After the MD-11 test landings, Boeing 747 and 757 simulators tested a wide range of possible situations. Simulations even helped develop a method of landing an airliner if it lost its complete hydraulic system as well as a wing engine, by transferring fuel to shift the center of gravity toward the working engine. The most extreme procedure was undertaken in a 747 simulator. The aircraft simulated the loss of the hydraulic system at 35,000 feet and rolled upside down. Then, the PCA mode was engaged, the airliner righted itself, leveled its wings, and made an approach nearly identical to that of a normal auto landing.